Table of Contents
Advertisement
1.
Input A control – attenuates the incoming audio signal at Input A jack
(channel A) between -∞ dB and 0 dB
2.
Input B control – attenuates the incoming audio signal at Input B jack
(channel B) between -∞ dB and 0 dB
3.
Freq control – adjusts the phase frequency for both channels between1
Hz and 200 kHz
4.
Det control – detunes the phase frequency of channel B over ±3.6
octaves (x12 resp. ÷12)
5.
Reso control – adjusts the resonance of the phaser (Q-factor) between
zero (1) and self-oscillation (∞) for both channels
6.
Emph control – adjusts the emphasis of resonance for both channels,
commonly
7.
Mix A control – mixes the original signal at jack
effect of channel A proportionally together
8.
Mix B control – mixes the original signal at jack
effect of channel B proportionally together
9.
Fb B 2 pos. toggle switch – activates ("on") the feedback loop of channel B
10. FB-Stage 4-pos. rotary switch – selects for both channels the stage for the
feedback loops, commonly
11. Fb A / Mode 3 pos. toggle switch – routes the channels A and B in three
different ways into parallel or serial modes
12. Out-Stage 4-pos. rotary switch – selects for both channels commonly the
effect output stage at the
13. Input sel 2 pos. toggle switch – selects for the
original inputs A or B
14. Input A jack (input) – audio input channel A
15. Input B jack (input) – audio input channel B
16. +CV A jack (input) – non-inverting CV-input to control the phase
frequency of channel A
17. -CV A jack (input) –inverting CV-input to control the phase frequency of
channel A
18. +CV B jack (input) – non-inverting CV-input to control the phase
frequency of channel B
19. -CV B jack (input) –inverting CV-input to control the phase frequency of
channel B
20. Res A jack (input) –CV-input (±5V) to control the resonance of channel A
21. Res B jack (input) –CV-input (±5V) to control the resonance of channel B
22. Emph A jack (input) –CV-input (±5V) to control the emphasis of channel A
CS-8 Series PHS-28 Rev1.01, Dec. 2013
Mix A
Mix B
and
-9-
Input A
with the phasers
Input B
with the phasers
controls and output jacks, resp.
Mix B
-control one of the
Advertisement
Table of Contents
