Table of Contents
Advertisement
INSTALLATION (continued)
MECHANICAL INSTALLATION
The following is a step-by-step procedure for installation of the Recirculating Hoods.
1. Uncrate the hood, being very careful not to dent or scratch the outer surface. NOTE Report any
damage to the delivering freight carrier and file a claim if appropriate. Refer to the installation
drawing for typical details of the ventilation system prior to hanging the hood. Check the nameplate
on the equipment to make certain it meets the specifications provided by the architect and or
engineer. If discrepancies exist, notify the manufacturer immediately.
2.
It's important that you have read and understand "Site Preparation" before continuing with the installation
of the hood. See Table on page 6 "EQUIPMENT PARAMERTUER".
3. Determine the exact location of the hood. Ensure support beams are structural support system is
the responsibility of the contractor and the structural engineer.
4. Use 1/2-13 threaded rod to hang the hood. Drill 5/8" holes in the structural support system using
dimensions provided below.
5. Each corner of the hood has a pre-punched hole. It is important that the 1/2-13 threaded rod that
will be used to suspend the hood is secured at these locations. Each hole has a 14 gauge steel
support plate that is riveted to the inside of the lid to strengthen the hood corners. Do not remove or
relocate these plates.
6. Raise the hood into position using high lifts or equipment jacks at each end of the hood to ensure the
hood is level. When the hood is elevated to the proper height, install 1/2-13 threaded rod between
the hood support plates and the modified supports in the ceiling.
7. Make final adjustments as needed to ensure that the hood is level. Maintain tension on all the rods
to ensure hood weight is evenly distributed.
6 "
5 / 1
1 1
F R O
N T
"
1 / 8
4 2
3/8" Top
Mounting Hole
9
3 5 "
3/8" Rear
Mounting Hole
IL2636b
3 9 / 3
2 "
3 3 / 4
"
1 5 3
/ 1 6 "
Advertisement
Table of Contents
