Adjusting The Frequency Crossover - Radio Shack XL-200 Owner's Manual

12-2016.fm Page 15 Monday, April 10, 2000 4:33 PM
3. Adjust
LEVEL (MIN/MAX)
fortable listening level.
4. Turn up the auto sound system's
volume control until the sound
begins to distort. Then immediately
turn the volume down to a point just
before where the distortion began.
Caution: Never turn up the auto
sound system's
more than needed to adjust the
audio level, or more than two-thirds
of its maximum volume.
5. Adjust
LEVEL (MIN/MAX)
sound is at the maximum level you
want the amplifier to produce.
6. Adjust the auto sound system's vol-
ume control to a comfortable listen-
ing level.
ADJUSTING THE
FREQUENCY
CROSSOVER
If you connected a subwoofer using the
steps in "Connecting a Subwoofer
(Bridged Connection)" on Page 12, set
X-OVER FREQ ON/OFF
just for your particular ve-
X-OVER FREQ
hicle's acoustics. The amplifier passes
through all frequencies at or below that
setting (45–400 Hz).
Note:
X-OVER FREQ
which the amplifier will pass frequencies
(from 45–400 Hz). You should not use it
to a com-
volume control
until the
to , then ad-
ON
selects the limit at
Operation
to adjust the sound you hear through
your main speakers.
15