Table of Contents
Advertisement
14. STEP Switch
Use this switch to select the steps 25kHz (button out). or 5kHz (button in) during frequency scan or microphone
UP/DOWN operation.
15. REV Switch
This switch is used to reverse the repeater shift (±600 kHz) and other transmit/receive frequencies (CH 13. 14). It
is a momentary non-lock type switch and returns to the normal out position when released.
16. MEMORY Channel Selector
This switch is used to select the desired memory channel. There are 15 memory channels. Of these, channels 0 ~
12 store frequencies including ±600 kHz shift. The other two channels. 13 and 14 are "ODD split" channels, storing
transmit and receive frequencies individually. Channel "14" is the priority channel.
17. PRIORITY ALERT Switch
This switch is used to check the priority "14" channel. Depress the switch and the priority channel can be
checked at about 6 second intervals regardless of the KEY/M. SEL switch position. Tone sounds when the priority
channel is in use.
18. PRIORITY OPER Switch
This switch is used to call up the priority ("14") channel By depressing the switch, the operating frequency is
switched to the priority channel.
19. TONE Switch
When this switch is pressed, the repeater control tone burst signal (1.750 Hz) is emitted for about 0.5 second at
the beginning of each transmission.
Advertisement
Table of Contents
