Microprocessor Control; I Feel Control Operation - Mitsubishi Electric MS09EW Service & Parts Manual

MICROPROCESSOR CONTROL
Wireless Remote Controller
SENDING SECTION
I
LCD
INDICATOR
r o o i
DRY
MASTER CONTROL
button
LO
FAN CONTROL
HI
bunon
S t 1 TEMP
SET TEMP.
bunons
AUTO STOP
TIMER CONTROL
AUTO SPRT
bunon
HOURS
TIME SETTING
bunons
TO0 COOL OKAY
TOO WARM
POWER
bunon
I
'I FEEL" CONTROL bunons
This figure shows
I FEEL CONTROL mode display.
[
INDOOR UNIT DISPLAY SECTION
I
I FEEL MONITOR
b b .
POWER
...
...
Once the controls are set, the same operation mode can be
repeated by simply turning the POWER switch ON.
Indoor unit receives the signal with a beep tone.
When the system turns off,
"3
min. time-delay function" will
operate to protect system from over load and compressor will
not restart for 3 minutes.
1. "I FEEL CONTROL" operation
(1
)
Press POWER button on the remote controller. Power
lamp of the indoor unit will tum on with a beep tone.
(2) Press the MASTER CONTROL button to set "I FEEL
. . . ".
And I FEEL MONITOR lamp lights with a beep tone.
(3) The operation mode is decided by the initial room
temp. at starting up the operation.
1
Initial Room Temp.
/
Mode
!
*Once the mode is fixed, the mode will not change by
room temp. afterwards.
*Under the AUTO START timer operation, the mode is
determined according to the room temperature 1 hour
before the set time.
When the system is stopped with the POWER button on
the remote controller, and restarted within 1 hour in "I
FEEL CONTROL" mode, the system operates in previous
mode automatically regardless of the room temp.
When the system is restarted after 1 hour, the operation
mode is decided by the initial room temperature at start-up
of the operation.
Example
Previous operation
COOL mode of
"I FEEL CONTROL" COOL mode of
or COOL mode