Advertisement
Slide the ACCESSORY TRAY (#8) (if so equipped) over the
1.
user right seat back post and down to make contact with the
SEAT HANDLEBAR.
Position the underside clamp bracket (A) around the SEAT
2.
HANDLEBAR and tighten the two clamp SCREWS and
WASHERS (B).
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN
MISE EN GARDE : VEILLER À NE PAS TROP SERRER
Align the four holes in the SEAT BACK (#5) with those in the
3.
SEAT BACK POSTS. Insert the four SCREWS (#1) and
WASHERS (#2) through the backside of the SEAT BACK
POSTS and into the SEAT BACK. Tighten the four SCREWS
with a hex key wrench.
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN
MISE EN GARDE : VEILLER À NE PAS TROP SERRER
Unfold the CONSOLE WIRE HARNESSES (C) from the POST
4.
extending from the FRAME.
Feed the WIRE HARNESSES at the top of the FRAME POST
5.
through the bottom of the CONSOLE SUPPORT ASSEMBLY
COLUMN. Continue pushing the WIRE HARNESSES until the
CONNECTORS at the end of the WIRE HARNESSES exit
through the opening at the top of the COLUMN. Gently pull the
WIRE HARNESSES to remove the slack.
Position the CONSOLE SUPPORT ASSEMBLY (#6) so that
6.
the HANDLEBAR is facing the user and slide the CONSOLE
SUPPORT ASSEMBLY into the FRAME POST (D), being
careful not to pinch the WIRES in the process. Align the holes
in the top of the CONSOLE SUPPORT ASSEMBLY with those
in the FRAME POST. Install the four CONSOLE SUPPORT
ASSEMBLY BOLTS (#3) to secure it into position. Tighten the
four CONSOLE SUPPORT ASSEMBLY BOLTS to 15-20 ft.
lbs.
NOTE: BE VERY CAREFUL NOT TO DAMAGE THE WIRES
WHEN PASSING THE BOLTS THROUGH THE HOLES.
TIGHTEN THE BOLTS SECURELY.
MISE EN GARDE :FAITES ATTENTION TRÈS À NE PAS
ENDOMMAGER LES FILS EN PASSANT LES BOULONS
PAR LES TROUS. SERREZ LES BOULONS SOLIDEMENT.
Align the LOCKING TABS of the 10-PIN CONNECTOR and
7.
the 4-PIN CONNECTOR (Models 9500HR) and plug them
together until they SNAP into place.
Model 8500 Only
8.
Remove the BATTERY DOOR (E) located on the back of the
DISPLAY CONSOLE (#7). Carefully pull the BATTERY WIRE
HARNESS (F) out of the BATTERY COMPARTMENT. Plug
the BATTERY (#11) into the BATTERY WIRE HARNESS
CONNECTOR. Carefully place the BATTERY and BATTERY
WIRE HARNESS into the BATTERY COMPARTMENT.
Replace the BATTERY DOOR.
THE SCREWS.
LA VIS.
THE SCREWS.
LA VIS.
7
F
11
E
6
3
D
4P
10P
4
C
Advertisement
