Haier JC-110GD JC-160GD Service Manual page 10

Electrical Requirement
Make sure there is a suitable power Outlet(220-240V)with proper grounding to
power the wine cooler.
Avoid the use of three plug adapters or cutting off the third grounding in order
to accommodate a two plug outlet ,This is a dangerous practice since it
provides no effective grounding for the wine cooler and may result in shock
hazard.
Install Limitations
Do not install your wine cooler in any location not properly insulated or heated
e.g. garage etc, Your wine cooler was not designed to operate in temperature
settings below 13℃ Centigrade.
Select a suitable location for the wine cooler on a hard even surface away
from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking
appliances etc, Any floor unevenness should be corrected with the leveling
legs located on the front and rear bottom corners of the wine cooler.
Your wine cooler is designed for free-standing installation only, It is not
designed for built-in application.
Initial Setup
Electronic Controlled Units:
Once you have plugged the unit into an electrical outlet, Let the unit run for at
least 30 minutes to acclimate itself before making any adjustments, during this
time the Red Wine light may stay on. During this time the Red Wine light will stay
INSTALLATION AND ACCESSORY PARTS
１０