hawos Billy Operating Instructions Manual page 7

Opening the grinder
Figure 6
Remove the
top grindsto-
ne by turning
it counter-
clockwise
Figure 7
The black
marks must
be located
over one
another
Figure 8
When
screwing the
grindstone
back into
place, make
sure that it
does not tilt
Figure 9
Make sure the
foam rubber
gasket is
properly
seated
(arrow).
Return the
funnel to its
previous
position and
secure it with
the brass
screws
Opening the grinder

Attention! Turn off the mill with the On/Off
switch and then disconnect the mains plug
before opening the housing to prevent the unit
from accidentally turning on – risk of injury!
• Remove the four brass screws on the top of the
mill housing (page 4, figure 1)
• Lift off the funnel (page 4, figure 2)
• Turn the top grindstone on the plastic ring (apply
considerable force!) counter-clockwise until it can
be removed (figure 6)
In order to reassemble the mill, position the mill so
that the flour outlet is pointing towards you.
• Place the top grindstone on the inner plastic ring
such that it is completely level.
• The black mark must be at "6 o'clock" over the
retainer (figure 7).
• Push the stone down gently from above and
screw it back until it locks into place (one
complete revolution and then to approximately
"10 o'clock"). For this, see figure 8.
Make sure the foam rubber ring is properly seated.
You can now return the funnel to its previous
position and secure it with the four brass screws
(figure 9).
7