hawos Billy Operating Instructions Manual page 4

4
Start-up
Please first read through the
section "Before first use" (P. 3)
and the safety notes (P. 2)!
Be absolutely sure to remove the
transport guard before first use!
You can remove the transport guard by removing the
four brass screws (figure 1) on the funnel plate and
lifting up the funnel (figure 2). Completely remove
the three red screws with a cross-slotted screw driver
(figure 3).
Check that the foam rubber gasket is properly seated
around the hole in the top grindstone (figure 4). You
can now return the funnel to its previous position
and secure it with the brass screws.
Milling
Once connected to a power supply, your hawos mill is
ready for use.
Place a bowl under the flour outlet and adjust the
fineness (figure 5). Then fill the funnel with grain and
turn on the mill.
Figure 1
Remove the
four bronze
screws with the
enclosed Allen
wrench
Figure 2
Lift the funnel
Figure 3
Remove the red
transport
screws
Figure 4
Make sure the
foam rubber
gasket is
properly seated
(arrow).
Now return the
funnel to its
previous
position and
secure it with
the brass
screws
Figure 5
Set the
fineness:
forward for
fine, back for
coarse
Start-up
3 2
1