NewAir AF-520B Owner's Manual page 6

Step 2. Fan Head Assembly (Fig. 2)
1. Remove the blade cap (B) by turning clockwise. Remove the plastic nut (D) by
turning counter clockwise.
2. Position the rear gille (E) over the motor shaft (F), make certain the handle is at
the top and the one notch in the rear of rear grill (E) cover fit over the three
prong on the motor housing(H).
3. Secure rear grille (E) by turning the plastic nut (D) clockwise and tightening
firmly.
4. Slide the fan blade (C), with the hollow interior of the blade facing toward rear
grille (E), onto motor shaft (F)
5. Secure Fan blade (C) onto motor shaft (F) by turning the blade
cap (B)counterclockwise until it firmly in place.
6. Loosen the bolt on the bottom of the Front Grill (A) and mount the Front
Grill (A) with the logo right side up to the Rear Grill (E) by snapping both
together firmly.Ensure all snaps around the Front Grill (A) are secure on the
Rear Grill (E).
7. Tighten the bolt on the bottom of the Front Grill (A).
Step 3. Final Assembly (Fig. 4)
1. Loosen the thumb screw (J) by turning it counter clockwise.
2. Always keep the water proof cover (L) match with the height adjustable
knob (O) when adjusting the internal pole (N).
3. Insert internal pole (N) into the neck joint and tighten by turning thumb
screw (J) clockwise. Make sure it is tight enough to support the fan head.
4. Attach the Misting Line holder (M) onto the Internal pole (N).
5. Secure the Misting Line (Q) to the clip under the Front grill (A) and the Misting
Line Holder (M).
Fasten
O
N
P
Fig. 1
B E
F
T
A
C D
U
http://www.NewAir.com
6
Fig. 2
J
N
M
O
Fig. 3
L
Fig. 4