Aux-In Operation; Gps Navigator Operation - CDI Commrider 7050 User Manual

AUX-IN Operation

Plug in/pull out AUX
During none phone call and duplex talkback state, just connect the Bluetooth and
AUX with cable to play, it will turn automatically to play A2DP music( being silence
if A2DP unconnected)
Manual switchover the AUX-IN function
Double click MFB to switchover among FM radio, AUX-IN, and mobile music play.

GPS navigator Operation

1- Make sure the GPS have the Bluetooth function. And after pairing and connecting,
the voice or music can be shared from the GPS navigator.
2- Mobile phone or intercom calls have higher priority than GPS audio. Mobile phone/
Intercom call will pause the GPS audio. The audio will be restored automatically after
call /intercom ended.
All Functions Priority Sequence
Phone call highest, Duplex talkback after, FM radio, A2DP music and Aux-in end
with equal priority.
Automatic shutdown function
The Bluetooth will turn off automatically after disconnect with any other device for
10 minutes .
Device Initiating to Factory state
1- Reset to factory settings : in power on state, press both MFB and Volume+ for 10 seconds till the
led indicator flashes red twice to reset the Bluetooth headset to factory state.
ALL PARING INFO WILL BE CLEANED UP AND ENTER TO AUTO PAIRING STATE.
2- Bottom Testing mould: in power off state, press both control botton and MFB for 10 seconds till the
led indicator flashes red/blue at same time and short press Volume+ to set the Bluetooth headset to
Botton testing state. Then the Led indicator will flash alternately according to every press/click .
3- MIC and speaker testing mould: in power off state, press both control botton and MFB for
10 seconds till the led indicator flashes red/blue at same time and short press Volume- to set the
Bluetooth headset to MIC AND SPEAKER testing state. Talk forward the microphone, the voice
comes out from the two speaker.