Table of Contents
Advertisement
Adjusting the Screen Image
Use the buttons on the front control panel to display and adjust the OSD menu items
that appear on the screen.
Standby Power On/Off
MENU/EXIT
[1]
Displays the Main Menu or exits the control screen and saves adjustments.
SOURCE/ENTER
[2]
Displays the highlighted OSD menu item.
Also a shortcut to toggle analog and Client.
Scrolls through menu options and adjusts the displayed OSD menu item.
▲/▼
Blue light filter (▼) / ViewMode (▲)
Power indicator
Blue = ON
Orange = Power Saving
Client indicator
Green = Activates Client
Dark = Client OFF
Flash blue = The network cable is connected on RJ45 port.
Turn on/off the Client power
Client
* Press and hold the Client button. The Client power will be turned off and
LED will be dark.
Do the following to adjust the display setting:
1. To display the Main Menu, press button [1].
NOTE: All OSD menus and adjustment screens disappear automatically after
about 15 seconds. This is adjustable through the OSD timeout setting in the
setup menu.
2. To select a
OSD menu item
Main Menu.
3. After the desired item is selected, press button [2].
4. To save the adjustments and exit the menu, press button [1] until OSD
disappear.
The following tips may help you optimize your display:
• Adjust the computer's graphics card to support a recommended timing mode
(refer to "Specifications" page for recommended setting specific to your Thin
Client Monitor). To find instructions on "changing the refresh rate", please refer to
the graphics card's user guide.
• If necessary, make small adjustments using H. POSITION and V. POSITION
until the screen image is completely visible. (The black border around the edge
of the screen should barely touch the illuminated "active area" of the Thin Client
Monitor.)
to adjust, press ▲ or ▼ to scroll up or down in the
7
Advertisement
Table of Contents
