Innovative Features; Operating Instructions - Accessory Power ReVIVE Refresh Instruction Manual

Innovative Features

- The Refresh Battery Charger can charge 1, 2, 3 or 4 AA or AAA Ni-MH or
Ni-CD batteries at a time.
- A Microcomputer IC Chip controls charging processes. The intelligent chip
will cut off charging when the batteries are full and automatically convert
to trickle charging mode. This ensures your batteries reach full capacity and
protects against overcharging.
- The IC Chip automatically identifi es non-rechargeable batteries, short-
circuited batteries and defective rechargeable batteries. Charging will only
be initiated if properly functioning batteries are inserted, protecting against
device malfunctioning.
- Overheat Protection: The Refresh Battery Charger will stop charging
automatically if the temperature of the charger or battery gets too high
during charging.

Operating Instructions

Connecting the Refresh Battery Charger to Power:
Choose the appropriate power adapter (AC or DC) for your charging needs.
The AC power adapter is for use in a wall outlet. The DC power adapter
should be used in your car's DC power outlet. Connect the appropriate
power adapter to a power source. Next, connect the barrel tip of the power
adapter to the (5) barrel power port on the Refresh Battery Charger (fi g.
2-1 on the next page). You will then see the (1) battery status LCD illumi-
nate green for 1 second. The Refresh Battery Charger is now connected to
power (The LCD will only illuminate for 1 second then turn off if there are no
batteries loaded in).