Zanussi ZRB23200XA User Manual page 3

Daily use
Do not place hot items near the plastic
components of this appliance.
Do not store flammable gas and liquid in
the appliance , because they may explode.
Do not place food products directly against
the air outlet on the rear wall.
Frozen food must not be re-frozen once it
has been thawed out.
Store pre-packed frozen food in accordance
with the frozen food manufacture s instruc-tions.
The appliances manufactures storage
recomm-endations should be strictly
adhered to. Refer to relevant instructions.
Do not place carbonated or fizzy drinks in
the freezer compartment as it creates press-
ure on the container , which may cause it to
explode , resulting in damage to the appliance.
Ice lollies can cause frost burns if consum-
ed straight from the appliance.
Care and cleaning
Before maintenance , switch off the appliance
and disconnect the mains plug from the
mains socket.
Do not clean the appliance with metal ob-
jects.
Do not use sharp objects to remove frost
from the appliance. Use a plastic scraper.
Installation
Important For electrical connection carefully
follow the instructions given in this instruction
manual.
Unpack the appliance and check if there are
damages on it. Do not connect the applian-
ce if it is damaged. Report possible damag-
es immediately to the place you bought it.In
Control Panel
Temperature Control Slider in refrigerator chamber
The temperature control slider is used to adjust
the refrigerator and freezer temeperature, the
slide on the thermostat is used to balance the
distribution of air flow volume of each compart-
ment. When the slider is turned down there will
be more air flow in the refrigerator and less air
flow in the freezer, so the refrigerator will be
cool faster. For normal operating use, keep the
slider in the centre normal position. You should
not need to adjust the temperature control dial if
the slider is kept at the normal setting.
Turning on the appliance and setting the thermostat
If it gets too cold in the chilled chamber with
the switch on "Min", just turn the switch back to
"normal", if the temperature gets higher in the
chilled chamber with the switch on "Max", just
turn the switch to "normal".
You switch on your appliance by connecting it to
your mains supply and setting the thermostat, the
thermostat control knob is located at the top.
www.zanussi.com
this case retain packing.
It is advisable to wait at least four hours
before connecting the appliance to allow the
oil to flow back in the compressor.
Adequate air circulation should be around
the appliance to prevent overheating.
achieve sufficient ventilation follow the
i nstructions relevant to installation.
Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor , conden-
,
ser) to prevent
The appliance must not be located close to
radiators or cookers.
Make sure that the mains plug is accessible
after the installation of the appliance.
Service
Any electrical work required to do the serv-
icing of the appliance should be carried out
by a qualified electrician or competent per-
son.
This product must be serviced by an autho-
rised Service Centre , and only genuine spare
parts must be used.
Environment protection
Wind path parts in refrigerator
The thermostat automatically regulates the
temperature interior refrigerator chamber and
freezer chamber, depending on what number you
have turned the thermostat control knob to:
1. If the ambient temperature is a higher
temperature (in summer), please set the
control knob at "5, 6 or 7" positing.
2. If the ambient temperature is a lower tempera-
ture (in winter), please set the control knob
at the "1 or 2" position.
3. please set the control knob at the 3 or 4
position for normal temperature conditions.
,
the risk of a fire
This appliance does not contain gasses
which could damage the ozone layer , in
either its refrigerant circuit or insulation
materials. The appliance shall not be dis-
carded together with the urban refuse and
rubbish. The insulation foam contains fla-
mmable gases: the appliance shall be
disposed according to the appliance regu-
lations to obtain from your local authorit-
ies. Avoid damaging the cooling unit , esp-
ecially at the rear near the heat exchang-
er. The materials used on this appliance
marked by the symbol
To
.
are recyclable.
Knob
3
3