Screw In And Out Of Modeling Lamp; Connect To Power Supply; Switch The Device On And Off - Foto Walser walimex pro VC-200 PLUS Instruction Manual

2. Demount reflector:
WARNING! Danger of burning on reflector, modeling lamp and flash
tube. Please let the device cool down for approx. 30 minutes.
• Remove safety cap from unlocking lever.
• Push back unlocking lever and keep pressed.
• Turn the reflector anticlockwise as far as it will go and take off from the
device.
• Mount protection cap.
See Demount and mount protection cap.
7.

Screw in and out of modeling lamp

WARNING
Posterior danger of bursting of flash tube through skin oil
Make sure not to touch the flash tube with bare hands accidentally.
B
A
1. Switch off device.
See Switch on and off of device.
2. Plug off power cord.
A Socket
B Modeling Lamp
13
3. Let the device cool down.
WARNING! Danger of burning on reflector, modeling lamp and flash
tube. Please let the device cool down for approx. 30 minutes.
4. Screw in modeling lamp:
• When the protection cap is mounted:
Demount protection cap.
See Demount and mount protection cap.
• Screw the modeling lamp carefully into the socket.
5. Screw out modeling lamp:
• Screw the modeling lamp carefully out of the socket.
• Mount protection cap.
See Demount and mount protection cap.
8.

Connect to power supply

1. Switch off device.
See Switch the device on and off.
2. Compare the local power supply with the connected load of the device.
If the values differ, please contact info@foto-walser.de or tel. +49
843294890.
3. Connect the power cord with the socket on the device and with the
power socket.
9.

Switch the device on and off

1. When the protection cap is mounted:
Demount protection cap.
See Demount and mount protection cap.
WARNING! Danger of fire through heat accumulation. Never use the
device with mounted protection cap.
14