Mount Reflex Umbrella (Optional); Switch On And Off Of Modeling Lamp - Foto Walser walimex pro VC-200 PLUS Instruction Manual

A
1. Loose locking lever.
2. Open locking knurl.
3. Mount the device on the tripod.
4. Tighten locking knurl.
5. Close locking lever.

12. Mount reflex umbrella (optional)

Just use reflex umbrellas with a rod diameter of 8-10mm
B
A
A Locking Lever
B Locking Knurl
C Tripod Mount
C
B
A Tripod Mount
B Locking Knurl
21
6. Let the device cool down.
WARNING! Danger of burning on reflector, modeling lamp and flash
tube. Please cool down approx. 30 minutes.
7. Open locking knurl.
8. Insert the rod of reflex umbrella through the opening in the reflector into
the fixture as far as it will go.
9. Tighten locking knurl
ADVICE: Don´t tighten the locking knurl too tight as to avoid damages on
the reflex umbrella.

13. Switch on and off of modeling lamp

1. Switch on device.
See Switch the device on and off.
2. Switch on modeling lamp:
Press control OUTPUT POWER once.
• The modeling lamp switches on.
• The signal MODEL
lights up.
3. Switch off modeling lamp:
Press push-button OUTPUT POWER twice.
• The modeling lamp goes out.
• The signal MODEL
ADVICE: If you don´t switch off the modeling lamp before switching off the
device, the modeling lamp will light up automatically, when switching on the
device again.
goes out.
22