Sebury K3 User Manual
  1. Manuals
  2. Brands
  3. Sebury Manuals
  4. Keypad
  5. K3
  6. User manual

Sebury K3 User Manual

Digital keypad
Hide thumbs
Table of Contents

Advertisement

Quick Links

K3
K4
Digital Keypad
Use s M anual
www.sebury.com.cn

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the K3 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Sebury K3

Summary of Contents for Sebury K3

  • Page 1 Digital Keypad Use s M anual www.sebury.com.cn...

  • Page 2: Table Of Contents

    K3/K4 user s manual Contents Introduction Introduction The K3/K4 uses the latest microprocessor technology to operate door strikes and security systems that require a momentary (timed) Specifications or latching dry contact closure. All programming is done through the keypad. Codes and operating...

  • Page 3: Intramural Interface Circuit

    Programming memory: Non volatile Eeprom memory IMPORTANT INFORAMTION There are no user serviceable parts contained within the K3 access control keypad. 2. Electric lock interface (See Figure 2) If holes are to be drilled before mounting onto a wall, check for hidden cables and/or pipes before drilling.

  • Page 4: Wiring

    K3/K4 user s manual K3/K4 user s manual Wiring The front cover can be permanently secured by using the short screw supplied K3/K4 Unplug the cable harness and connect the necessary cables, (See Figure 5). showed as Figure 6 for special power Supply connections, this power will make controller work stablly .

  • Page 5: Power Up

    After all wiring is complete and the unit face plate is attached to the +12V back plate, apply 12Vdc power to the unit. READY LED (the red BELL2 Green LED) lighting on, ACCEPT LED(the yellow LED) flashing at K3. White BELL1 Annunciator READY LED(the red LED) lighting on, ACCEPT LED(the red LED)

  • Page 6: Delete User Card Or Cards

    Press: new time from 00-99 seconds the # key. 1st card must be 000 up to 999. Then the K3/K4 control station added a user card it was auto added a user code with 1234. Setting Alarm Signal Output Time...

  • Page 7: Resetting To Factory Default Setting

    Non volatile Eeprom memory Operating Temperature to 60 the jumper connector onto the pins 1 & 2 as per figure 4. After Keypad Housing ABS+PC switching power on remove jumper, the K3/K4 will give a beep and K3(90mm 60mm 27mm) Dimensions K4(120mm...

This manual is also suitable for:

K4

Table of Contents

Save PDF