: prior to drilling, make sure there are no cables or other pipelines behind the wall to avoid
damage. Remember that the screws on the wall should be fixed and firm to ensure the safe
installation of the heater on the wall. Please note the safe distance mentioned below.
During installation, the heater must be maintained a sufficiently safe distance from
•
combustible materials/gases and away from water.
During wall-hanging installation, keep the installation height from the ground greater
•
than 15cm. The Hanging-type heater should be no less than 50cm away from the ceiling.
Make sure the heater shell, power cord and power plug are all intact.
•
Check that the rated voltage on the model label on the heater matches that of the power
•
outlet being used: 220~240V, 50/60Hz.
Temperature
Control Knob
Turn the temperature control knob clockwise to the end, then press the level-I power switch to
switch on low-level heating, or the level-II switch for high-level heating. If both levels are
switched on, the heater will be working at maximum power.
3