Advertisement
Why is the pouch bigger than the document?
Pouches should always overlap the document by 2-3mm on all 4 edges so the document is fully encapsulated and
protected.
How do I laminate a document that is smaller than the pouch?
Do not trim the pouch before laminating. Just insert the document into the pouch close to the presealed edge
and ensure left and right margins are equal. Trim the pouch after lamination.
Why does the laminator smell when it is hot?
This smell comes from the rollers and the heating element when the machine is new. It is normal for hot roller
laminators and will disappear after some hours of operation. The odour is not hazardous.
Is it normal that the top of the laminator is very hot?
Yes. Because the heating elements are wrapped around the rollers, heat will build up on the laminator house.
Why is the pouch getting stuck in the laminator?
There are three main causes:
1. If low quality pouches have been used, excess glue could have built up on the roller
2. The temperature setting may be too high
3. The pouch may have been misfed
Why are my laminated documents wavy from left to right?
This can occur if the laminator is too hot for the document. Check the temperature setting is correct for the
pouch type. In some cases a better result may be achieved by using a lower temperature than the pouch
thickness indicates. If the temperature can be adjusted further, try using a thicker pouch.
Is maintenance of the machine needed?
If the laminator is used correctly with GBC Pouches, machine maintenance is not necessary. Cleaning of the
rollers is recommended after every laminating session. To clean roller, run a sheet of white cardboard through
the laminator 2 – 3 times in hot operation mode or GBC Cleaning Sheets.
Advertisement
