Trimming The Image - Canon EOS M Basic Instruction Manual

Trimming the Image

Tilt correction
1
On the print settings screen, select [Trimming].
2
Set the trimming frame size, position, and aspect ratio.
The image area within the trimming frame will be printed. The
trimming frame's aspect ratio can be changed with [Paper settings].
Changing the trimming frame size
Tap the screen and pinch two finger closed or spread them apart as
necessary to change the size of the trimming frame. The smaller the
trimming frame, the larger the image magnification will be for printing.
Moving the trimming frame
Press the <Wj/i>/<XL> /<YA>/<ZO> button to move the
frame over the image vertically or horizontally. Move the trimming
frame until it covers the desired image area.
Rotating the frame
Pressing the <B> button will toggle the trimming frame
between the vertical and horizontal orientations. This enables you
to create a vertically oriented print from a horizontal image.
Image tilt correction
By turning the <5> dial, you can adjust the image tilt angle up to
±10 degrees in 0.5-degree increments. When you adjust the
image tilt, the <O> icon on the screen will turn blue.
3
Press <Q/
The print settings screen will reappear.
You can check the trimmed image area on the upper left of the
print settings screen.
You can crop the image and print only
the trimmed portion as if the image was
recomposed.
Set the trimming right before printing.
If you set the trimming and then set the
print settings, you may have to set the
trimming again before printing.
> to exit the trimming.
0
wPrinting
273