Panasonic VIERA TH-L32D25Z Operating Instructions Manual page 77

Problem
Due to the digital reception technologies involved, quality of the Digital TV signals may be
relatively low in some cases, despite good reception of Analogue TV channels.
Unable to receive signals
with a high-performance
aerial
Interference or
frozen / disappearing
image in Digital TV
TV goes into Standby
mode
The remote control does
not work or is intermittent
●
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
Aerial Output
Aerial
Input
VCR
Aerial Output
terminal
●
Check "Digital TV Signal Condition" (p. 32).
If "Signal Quality" or "Signal Strength" are displayed in
red, check aerial. If problem persists, consult your local
Panasonic dealer.
●
Turn the TV off with the Mains power On / Off switch, then
turn it On again.
●
Auto power standby function is activated.
●
The TV enters Standby mode about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 3)
●
Has the TV been switched On?
●
Point the remote control directly at the front of the TV (within
about 7 m and a 30 degree angle of the front of the TV).
●
Situate the TV away from sunshine or other sources of
bright light not to shine on the TV's remote control signal
receiver.
Actions
(Individual aerial)
Splitter
Aerial Input
(Individual aerial)
77