For Vigor2930Vn - Draytek Vigor2930 Series Quick Start Manual

1 . 1 . 3 F o r V i g o r 2
1 . 1 . 3 F o r V i g o r 2
LED
ACT (Activity)
DoS
CSM
WLAN
WAN1/2
MGMT
Phone 1/2
LED on Connector
Left LED
WAN 1/2
(Green)
Right LED
(Green)
Left LED
LAN 1/2/3/4
(Green)
Right LED
(Green)
Interface
Factory Reset
Restart
Phone (1/2)
WAN (1/2)
LAN (1-4)
PWR
ON/OFF
9 3 0 V n
9 3 0 V n
Status
Blinking
Off
On
Blinking
On
On
Blinking
On
Blinking
On
Blinking
On
Off
Blinking
On
Off
Blinking
On
Off
On
Off
Blinking
On
Off
Description
Restore the default settings. Usage: Turn on the router (ACT LED is blinking).
Press the hole and keep for more than 5 seconds. When you see the ACT LED
begins to blink rapidly than usual, release the button. Then the router will restart
with the factory default configuration.
Restart the router forcefully.
Connecters for PSTN phones.
Connecters for remote networked devices.
Connecters for local networked devices.
Connecter for a power adapter.
Power Switch.
Explanation
The router is powered on and running normally.
The router is powered off.
The DoS/DDoS function is active.
It will blink while deleting an attack.
The profile of CSM (Content Security
Management) for IM/P2P application is active. (It
is enabled from Objects Setting >> CSM Profile).
Wireless access point is ready.
It will blink while wireless traffic goes through.
The WAN1 or WAN2 connection is ready.
It will blink while transmitting data.
The router is managed (handled) by Telnet.
It will blink while being managed by IE browser.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected with 10Mbps.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected with 10Mbps.
4