Table of Contents
Advertisement
Oven control panel beeps and
displays any F or E code error.
Soil not completely removed after
self clean.
Appliance is not level.
Fan noise occurring after the oven is
turned off.
•
Oven control has detected a fault or error condition. Press STOP/CLEAR to clear the
error code. Try bake or broil function. If the F or E code error repeats, turn off power to
appliance, wait 5 minutes and then repower appliance. Set clock with correct time of
day. Try bake or broil function again. If fault recurs, press STOP to clear.
•
Self Clean was interrupted. Review
•
Excessive spills on oven bottom. Clean before starting self clean.
•
Failure to clean soil from the oven frame, the door liner outside the oven door gasket, and
the small area at the front center of the oven bottom. These areas are not in the self-
cleaning area, but they get hot enough to burn on residue. Clean these areas before
starting the self-cleaning cycle. Burned-on residue can be cleaned with a stiff nylon brush
and water or a nylon scrubber. Be careful not to damage the oven gasket.
•
Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
•
Kitchen cabinet alignment may make oven appear not level. Be sure cabinets are square
and have sufficient room for appliance clearance.
•
Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
•
Some models are equipped with a cooling fan that runs during the cooking process to
cool internal electronic components. It is normal for this fan to continue to run for an
extended period of time, even when the oven is off.
"Self Clean"
on
33
Before You Call
page
25.
Hide quick links:
Advertisement
Table of Contents
