Quick Reference Guide 1. Prior to installation, please ensure: a. The fireplace operates properly by plugging the power supply cord into a conveniently located 120 volt grounded outlet. b. The light bulb in your fireplace is in good condition. Light bulbs may become loose during shipping.
IMPORTANT SAFETY INSTRUCTIONS_________________________________________ When using electric fireplaces, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: Read all instructions before using this heater. 2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as surfaces near the heater outlet or light bulbs.
PACKING LIST______________________________________________________________________ Parts list Quantity A. Fireplace/Firebox …..………………………………………………………………………………………………………… 1 B. Mounting Plate ………………………………………………………………………………………………………………... 1 C. Glass Front…………………………………………………………………….…………………………………………………… 1 D. Remote Control ………………………………………………………………………………………………………………… 1 E. Instruction Manual ……….…………………………………………………………………………………………………. 1 P a g e...
INSTALLATION INSTRUCTIONS________________________________________________ A. Wall Installation Due to the many different finish materials used on walls, it is highly recommended that you consult your local builder before you install this fireplace on the wall. 1. The fireplace may be hanged on any wall surface that can support its weight and where it can be leveled.
FIREBOX DIMENSION DIMENSION with 1/2” MODEL# ALLOWANCE Width Height Depth Width Height Depth DF-EFP1313-BLT 82.21” 21.34” 7.75” 82.71” 21.84” 5.00” 3. Lift fireplace and insert into opening. Adjust the unit to achieve the desired amount of depth. P a g e...
Page 8
4. Level the fireplace. 5. Drive mounting screws into mounting brackets on the unit and the wall studs. Side View Wall Installation Built-in Installation P a g e...
C. Coals and Crystal Installation Once fireplace is shipped, a standard coal is already attached to the unit. To change from Coals to Crystal 1. Unplug unit from the wall and ensure controls are switched off. 2. Remove the glass face from the firebox unit and place the glass in a safe location. 3.
5. The fireplace must not be modified in any way or used for purpose other than those recommended by Yosemite Home Decor. 6. Please observe these instructions as failure to do so may result in electric shock or other injury.
OPERATING INSTRUCTIONS____________________________________________________ This section will explain the function of each convenient control. A. Operation by Control Panel The control panel is located on the right hand side of the fireplace. (Figure 8) Main Power Switch On/Off Switch Flame Effect Dimmer Switch Heater Low Heat 675 W Heater Maximum Heat 1350 W...
Page 12
B. Operation by Remote Control 1. Prior to use, the handheld remote control requires installation of one (1) coin-cell battery. 2. Remove the cover on the rear of the remote control by sliding backwards. Install the batteries as shown and then slide the cover back into original position. 3.
TROUBLESHOOTING GUIDE ____________________________________________________ For any questions about the product, installations, returns and/or parts replacement, please call Yosemite customer service at phone # 1-800-305-9872 or fax to 559-276-8738 and/or email us at service@yosemitehomedecor.com PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION 1. Check that unit is plugged into a Power cord was not standard 120V outlet.
Repair or replacement is at the option of Yosemite Home Décor. Defects must be brought to the attention of the Authorized Yosemite Home Décor Dealer from which you purchased your appliance. Evaluation and course of action will be determined by the Authorized Yosemite Home Décor Dealer.