Summary of Contents for Yosemite Electric fireplace
Page 1
Electric Fireplace Electric Fireplace Instruction Manual Instruction Manual Electric Fireplace Packing List Electric Fireplace Packing List Electric Fireplace Remote Control AAA battery Fastener Package Instruction Manual Yosemite Home Décor 1-800-305-9872 www.YosemiteHomeDecor.com www.YosemiteHomeDecor.com P a g e...
MAINTENANCE. The heater on your electric fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again.
IMPORTANT INSTRUCTIONS WARNING You should read and always follow the important instructions below to reduce the risk of fire, electric shock, and injury to persons. 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as surfaces near the heater outlet or light bulbs.
Page 4
13. All electrical heaters have hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored or where the unit will be exposed to flammable vapours. 14. Do not modify this heater. Use it only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.
INSTALLATION This section provides step-by-step instructions for installation of your fireplace insert. Site Selection Review and consider all of the following conditions for installation: • Dimensions of the unit • Unit requires a minimum of two (2) wall studs in order to ensure a secure installation. The fireplace insert comes completely assembled and wired.
Existing Fireplace Installation 1. Seal all drafts and vents with non-fibrous insulation materials to prevent chimney debris from falling into the fireplace insert. CAUTION Do not install into an existing fireplace that is prone to leaks or dampness. 2. Cap the top of the chimney flue to prevent rain from entering. Plug the fireplace into a 15A/120V outlet.
Page 10
Wall Construction Installation Select a suitable location that is not susceptible to moisture or dust. Keep away from high traffic areas. Also, keep away from things that may catch fire such as drapes and furniture etc. 2. Use studs to frame an opening, make sure to create an allowance of ¾ inches (2.0 cm) based on the inserts’...
GROUNDING INSTRUCTIONS This heater is for use on 120 volts. The cord has a plug as shown at A in Figure. An adapter as shown at C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.
OPERATION This section will explain the function of each convenient control. This section will explain the function of each convenient control. NOTE The heater may emit a slight, harmless odor when first used. This odor is a The heater may emit a slight, harmless odor when first used. This odor is a normal condition normal condition caused by initial heating of internal heater parts and will not occur again.
Page 13
If no batteries installed or the batteries are not working, the remote controller will be unusable. To use the remote controller effectively, point it to the electric fireplace and keep a distance of 1-5 meters.
II. Operation 1. Open the light bulb area: The light bulb area is on the back of electric fireplace, see “E”. There are 6 screws on it. Loosen the screw, and then you can open it. (Right figure) 2. Examine the bulbs to determine which bulbs require replacement.
Page 15
Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.