Operation - Betec IceBoy Instruction Manual

Safety Notice
In order to avoid any accident,please refer to following operation:
1. To reduce the risk of fire, electric shock or injury when using the Ice maker, follow these basic
precaution.
2. Plug into ground adapted outlet
3. Disconnect power before servicing
4. Do not remove ground prong
5. Do not use an adapter
6. Do not use an extension cord
7. Do not pull directly on wire when plugging or unplugging the unit.
8. If ice is abnormal, please call the seller
9. It is normal for the compressor and condenser surface to reach temperatures between 70°C and
90°C during operation and surrounding areas may be very hot. Please don't touch it.
10. Due to fast freezing, ice cubes may appear "Cloudy". This is trapped air in the water and it will not
affect quality or taste of ice.
11. Please move the drawer at least 2 cm out so as to avoid any metalic components are rusted.
Electrical Requirements
Voltage: 220 - 240V / 50Hz
Fuse: AC 250V, 3.15A, 5 x 20
Space Requirements
During transportation, the incline angle of the cabinet should not be over 45°C.
Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed
System.
The Ice maker should be placed horizontally on a properly levelled surface.
To ensure proper ventilation for your Ice maker allow 150 mm of space at the top, the back and on
each side so as to provide a better ventilation condition.
Before using the Ice maker for the first time, please wait 2 hours after positioning it.
Clean the machine frequently so as to make sure the ice is edible.
Notice: Do not install the Ice maker near an oven, radiator, or other heat source.
1. Take out the drawer and fill the water reservoir with water. Make sure the water level in the water
reservoir is not over the Ice collecting tray.
2. Press ON button to turn unit on. The ice maker begins to work.

OPERATION

1. Plug in the machine into the socket.
2. Add water to the water tank with cup included in the machine.
3. Press "ON" to start the machine.
4. Water is pumped into the water tray from the water reservoir. It takes about 30 seconds
5. Ice making cycle begins. The evaporator in the water tray starts to form ice onto the evaporator
fingers.
6. It takes about 6 to 18 mintues(depending on the water temperature) for the ice making cycle to
complete. Once completed, the water tray will tilt forward; the remaining water will flow back to
the water reservoir and the ice cubes will drop from the fingers. You will hear a sound as the ices
cubes are released.Ice are droped to the ice basket directly
7. In about 30 seconds, the water tray will tilt backward. Once the water tray returns to its leveled
position,the second ice making cycle begins.
8. Press "OFF" to stop the machine.
9. If is on if still want to make ice, then add water to the water tank, same as step 2.
10. Also you can set the clock, automatically turn on and turn off time via following steps: