Table of Contents
Advertisement
Venting Methods
IMPORTANT:
•
NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or
garages. All exhaust must be ducted to the outside.
•
Use metal/aluminum duct work only.
•
Fasten all connections with sheet metal screws and tape all joints with certified Silver Tape or Duct Tape.
•
Use caulking to seal exterior wall or roof opening around the cap.
:
Venting Methods
•
Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow may be needed.
•
This range hood is factory set for vertical venting using round or rectangular vent adapter but can be con-
verted to horizontal venting by swapping the round vent adapter on top with rectangular vent adapter behind
the range hood as shown below:
Option 1:
Recirculate venting
(available with 2000 Class only)
Type 1:
3-1/4 x 10-inch rectangular vent
adapter behind the range hood.
Charcoal Filter Installation
NOTE: The charcoal filters are preinstalled if you purchased the range hood with re-circulating kit from us.
1.
Remove aluminum filters on hood.
2.
Position the charcoal filter onto the motor and turn until it locks. Re-install aluminum filters.
3.
Charcoal filters must be replaced after 120 hours of use (or approximately every 2 to 3 months based on the
average of 1 to 2 hours of daily cooking time). Available at your local resellers.
Option 2:
Horizontal wall venting
Side wall cap
Type 2:
3-1/4 x 10-inch rectangular vent
adapter on top of the range hood.
Option 3:
Vertical roof venting
Roof cap
Type 3:
6-inch round vent adapter on top
of the range hood.
Page 7
Advertisement
Table of Contents
