Table of Contents
Advertisement
Maintenance
SAFETY WARNING: Never put your hand into area housing the
fan while the fan is operating!
For optimal operation, clean range hood & all filter/oil container regu-
larly. Regular care will help preserve the range hood's performance &
appearance.
Cleaning Exterior Surfaces:
•
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent (e.g. Comet
Power Scruv
, EZ-Off
®
surface. For heavier soil use liquid degrease such as "Forumla 409
•
If hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the hood. Avoid getting
cleaning solution onto or into the control panel. Follow directions of the stainless steel cleaner. CAUTION: Do not
leave on too long as this may cause damage to hood finish. Use soft towel to wipe off the cleaning solution, gently
rub off any stubborn spots. Use dry soft towel to dry the hood.
•
After cleaning, you may use non abrasive stainless steel polish such as 3M
luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
•
DO NOT allow deposits to accumulate or remain on the hood.
•
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and cause rusting.
•
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel
for extended periods. Many of these compounds contain chemicals, which may be harmful. Rinse with water after ex-
posure and wipe dry with a clean cloth.
Cleaning Aluminum Grease Filter / Stainless Steel Filterless Grill:
•
The aluminum filters fitted by the factory are intended to filter out residue and grease from cooking. It need not be re-
placed on a regular basis but are required to be kept clean. Filters should be cleaned after every 30 hours of use.
•
Remove and clean by hand or dishwasher. Spray "Formula 409
if heavily soiled. Dry filters and re-install before using hood.
IMPORTANT: Drain oil from oil containers before oil and residue overflow!
Replacing Filters:
•
Should filters wear out due to age and prolonged use, replace with following part number: SV168/198-ACS-AF/SF
•
Note: Also replace damaged filter that has punctured or broken mesh, bent or broken frame.
Replacing J4 Type Halogen Light Fixture:
•
When the range hood uses J4 type halogen light fixture: 20W 12V (Product ID: SV-ACS-HAL20W).
•
Make sure the range hood is unplugged or turn OFF breaker and the lights are cool to touch.
•
Place a flat-head screwdriver between light housing and hood body, gently pry up the light housing and search for the
metal clip.
•
Apply force to the metal clip and pull out the light fixture. Disconnect the power cable and discard the old light fix-
ture.
•
Reverse the steps to install a new halogen light fixture. Turn ON breaker and range hood to test for operation.
Light Housing
Hood
Body
oven cleaner), or steel wool/scoring pads, which will scratch and damage the stainless steel
®
Flat-head Screwdriver
WARNING
Hazard of Burns!
Light bulb become extremely hot when turned on.
DO NOT touch bulb until switched off and cooled.
Touching hot bulbs could cause serious burns.
" or "Fantastic
" brand cleaner.
®
®
or ZEP
, to polish and buff out the stainless
®
®
" or equivalent degreasing detergent and leave to soak
®
Metal Clip
Power Plug
Page 22
Advertisement
Table of Contents
