Sony HDR-SR10 Handycam Operating Manual page 142

108
wf----------..
[I]
Active Interface Shoe n~""aceSlloe
The Active Interface Shoe supplies
power to optional accessories such as a
video light, a flash, or a microphone.
The accessory can be turned on or off as
you operate the POWER switch on your
camcorder. Refer to the operating
instructions supplied with your
accessory for details.
The Active Interface Shoe has a safety
device for fixing the installed accessory
securely. To connect an accessory, press
down and push it to the end, and then
tighten the screw. To remove an
accessory, loosen the screw, and then
press down and pull out the accessory.
• When you are recording movies with an
external flash (optional) connected to the
accessory shoe, tum off the power of the
external flash to prevent charging noise
being recorded.
• You cannot use an external flash (optional)
and the built-in flash at the same time.
• When an external microphone (optional) is
connected, it takes precedence over the
Built-in microphone (p. 110).
[2]
Remote sensorlInfrared port
Point the Remote Commander (p. 111)
towards the remote sensor to operate
your camcorder.
@]
Camera recording lamp (76)
Lights up in red during recording.
Flashes when remaining hard disk space
or battery power is low.