Light Bulb Replacement - Whirlpool VM11D-8P Care And Use

Light Bulb Replacement
Cooktop Light Oven Light
REMOVE SCREW
Clean off the grease and dust on
To replace cooktop light, f_rst To replace your oven light, first hood surfaces often. Use a solution
disconnect power at main fuse or disconnect power at main fuse or of warm water and detergent.
circuit breaker panel or pull circuit breaker panel or pull About 1 tablespoon of ammonia
plug. plug. Remove the top grill by may be added to the water. Take
Remove screw on right side of taking out the 2 screws that hold it care not to touch the filters and
light compartment cover and lower in place, enamel surfaces with this solution;
cover until it stops, ammonia will darken metal.
Next, remove the single screw
Be sure bulbs to be replaced are located above door near center of
cool before removing. Break the oven that secures light housing.
adhesive seal by gently unscrewing Replace burned-out bulb with a
the bulbs. Replace with 40-watt 30-watt incandescent bulb,
incandescent bulbs available from available from your supplier.
your supplier. High intensity 40-
watt bulbs, which are available in
supermarkets and hardware stores,
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
20