Removing A Headlamp; Changing A Bulb; Lamp Assembly Condensation; Horizontal Aim Adjustment - Ford ESCAPE Owner's Manual

2015
Hide thumbs Also See for ESCAPE:
Table of Contents

Advertisement

5. Locate the vertical adjuster on each
headlamp. Using a Phillips #2
screwdriver, turn the adjuster either
clockwise or counterclockwise in order
to aim the headlamp.
6. Close the hood and turn off the lamps.

Horizontal Aim Adjustment

Horizontal aim is not required for this
vehicle and is non-adjustable.

REMOVING A HEADLAMP

2
E142468
1.
Make sure the headlamp control is in
the off position and open the hood.
2. Remove the two screws from the
headlamp assembly.
3. Carefully pull the headlamp assembly
as far as possible towards the front of
the vehicle to disengage it from the
lower fixing point.
4. Carefully lift the outer side of the
headlamp and remove it.
5. Disconnect the electrical connector.
Escape (TM2) Canada/United States of America, enUSA, Second Printing
Maintenance

CHANGING A BULB

Lamp Assembly Condensation

Exterior lamps are vented to
accommodate normal changes in pressure.
Condensation can be a natural by-product
of this design. When moist air enters the
lamp assembly through the vents, there is
a possibility that condensation can occur
when the temperature is cold. When
normal condensation occurs, a thin film of
mist can form on the interior of the lens.
The thin mist eventually clears and exits
through the vents during normal operation.
2
Clearing time may take as long as 48 hours
under dry weather conditions.
Examples of acceptable condensation are:
Presence of thin mist (no streaks, drip
marks or droplets).
Fine mist covers less than 50% of the
lens.
Examples of unacceptable moisture
(usually caused by a lamp water leak) are:
Water puddle inside the lamp.
Large water droplets, drip marks or
streaks present on the interior of the
lens.
Take your vehicle to a dealer for service if
any of the above conditions of
unacceptable moisture are present.

Replacing Headlamp Bulbs

plastic base and do not touch the glass.
The oil from your hand could cause the
bulb to break the next time the headlamps
are operated.
229
WARNING
Handle a halogen headlamp bulb
carefully and keep out of children's
reach. Grasp the bulb by only its

Advertisement

Table of Contents
loading

Table of Contents