D-Link AirPlus XTREME G DWL-G650 Manual page 15

Using the Configuration Utility (continued)
Frequency:
Select 802.11b/g - 2.4GHz or
802.11b.
Super G:
Enable or Disable the Super G
function (108Mbps). In order to
communicate, all devices must
share the same setting for this
feature.
Starting Ad-Hoc Network:
This setting is always 2.4GHz.
Ad-Hoc Channel:
All devices in the Ad-Hoc net-
work must be set to the same
channel.
Profile IP Settings:
You can Enable or Disable the IP Settings portion of your profile here. If you select
Disable you will need to configure the IP address information each time you connect to
a network. If you select Enable you will maintain the same IP address information each
time you connect to a network.
Power Mode:
Disable -This default setting consumes the most power.
Enable - This setting consumes the least power.
Launch Utility on Startup:
Select Enable or Disable.
Data Packet Parameter:
Set the Fragmentation Threshold and the RTS Threshold. Please see below.
Fragmentation Threshold:
This value should remain at its default setting of 2432. If you experience a high packet
error rate, you may slightly increase your Fragmentation Threshold within the value
range of 256 to 2432. Setting the Fragmentation Threshold too low may result in poor
performance.
RTS Threshold:
This value should remain at its default setting of 2432. If inconsistent data flow is a
problem, only a minor modification should be made.
Click Apply if you have made any changes.
Advanced
15