Volvo XC60 Owner's Manual page 171

The following table shows some of the situa-
tions that can cause the message to be dis-
played and suggested actions.
Cause Action
The area of the Clean the wind-
windshield in front of shield or remove the
the sensor is dirty or ice/snow.
covered by ice or
snow.
The laser sensor's Remove the
field of view is obstruction.
obstructed.
04 Comfort and driving pleasure
CAUTION
If a crack, scratch or stone chip should
occur in the section of the windshield in
front the laser sensor and covers an area of
approximately 1/50 x 1/10 in. (0.5 x 3 mm)
or larger, contact a trained and qualified
Volvo service technician to repair or replace
the windshield (see the illustration showing
the location of the sensor on page 167).
Failing to do so may result in reduced City
Safety™ functionality.
To help prevent reduced functionality,
please also observe the following:
•
If the windshield is replaced, use the
same type or a windshield approved by
Volvo.
•
When replacing windshield wipers, use
the same type or ones approved by
Volvo.
City Safety™
The laser sensor
The upper decal describes the laser beam's
classification and contains the following text:
Invisible Laser radiation – Do not view directly
with optical instruments (magnifiers) – Class
1M laser product.
The lower decal describes the laser beam's
physical data and contains the text:
IEC 60825-1:1993 + A2:2001. Complies with
FDA performance standards for laser products
except for deviations pursuant to Laser Notice
No. 50, dated July 26th, 2001
The laser beam's physical data is listed in the
following table:
04
}}
169