Xo XOI21SMUA User Instructions page 9

INSTALLATION INSTRUCTIONS
INSTALLATION - VENTED TO THE OUTSIDE
1. FIXING THE HOOD TO THE LOWER
PART OF THE WALL CABINET:
This type of appliance must be fitted inside
a cabinet or inside another type of support
structure. The overall measurements of the
range hood are given in figure 1-2. Before
proceeding with range hood installation,
remove grille D by pressing the two side
buttons A, as shown in figure 3.
Fix the appliance in place using 8 screws
(not supplied) which are suited to the
type of cabinet. To install the range hood
correctly, first fit the 4 screws A and then
the 4 screws B, in accordance with the
diagram in figure 4. After fixing the range
hood to the lower part of the cabinet, place
grille D (Fig.4) back in the correct position.
During this procedure, make sure that
grille D is fastened properly.
The appliance expels the fumes through
an outside wall or a duct. It is necessary to
buy a telescopic pipe in accordance with
the standards in use (inflammable) and
connect it to flange H (Fig.5).
IMPORTANT - The range hood must
be secured to wall studs or use drywall
anchors capable of supporting 75 lbs.
Fig.1
19-7/16" - 26-7/16"
20-9/16" - 27-8/16"
6/16"
Fig.2
- 9 -
5-14/16"
10-1/16"
10-12/16"