Advertisement
SECTION 3 - USING AND CLEANING
IMPORTANT: GENERAL NOTES ON CLEANING
Disconnect unit from electricity supply prior to cleaning
Never use a coarse abrasive to clean exterior panels. A soft cloth with a warm water
and detergent solution is sufficient.
Never attempt to steam clean a unit or hose it down with a jet of water.
LD22 GRILL
Using the Grill
Drip tray must be in position at all times when in
any of 5 runner positions with the top position recommended for best results when toasting
bread. Maximum heat setting is required and the full grid surface may be covered.
For best results when cooking meat, a brander pre-heat time of 30 minutes is recommended.
Any runner position may be used and the brander can be tilted to suit individual
requirements.
Cleaning a Grill
Clean when cool using a detergent/water solution and dry thoroughly. Use a soap-filled pad
to remove stubborn stains. Take care when using these on stainless steel. Never use harsh
abrasives on such a surface. Ensure excess water does not run into the element or terminal
compartment. The aluminium brander should be left under full heat until the debris has
carbonised. The debris can then be removed with a wire brush.
Supplied with toast grid and removable drip tray as
standard. A cast aluminium brander is available as an optional
extra.
Grill Control Switch
Element is controlled by turning the energy regulator clockwise
to enable infinite variable heat settings between 1 and 6.
operation. The grid may be used in
Advertisement
