Mirage HDMIRAGE10 Instruction Manual page 15

Leak Testing
• To be performed in a well ventilated area.
• Confirm all control knobs are in the off position.
• Open the gas control valve on the bottle or regulator.
• Check the leaks by brushing a solution of 1/2 water and 1/2 soap over the gas
system joints, including all valve connections, hose connections and regulator
connections.
• NEVER USE AN OPEN FLAME to test for leaks at any time.
• If bubbles form over any of the joints, there is a leak.
• Turn off gas supply and retighten all joints.
• Repeat test. If bubbles form again, do not use the patio heater. Please contact
your local gas dealer for assistance or the helpline stated in this manual.
• Leak test annually and whenever the gas bottle is removed or replaced.
Gas and Regulator
• The gas hose must be connected in accordance with these instructions. When installed
correctly all parts of the hose should be contained within the Patio Heater pole and gas
cylinder chamber. No part of hose should be outside of the Patio heater body where it
could be a trip hazard or could be accidently damaged.
This appliance is for propane use only.
• See instructions supplied with regulator for correct use and attachment.
• Gas bottles should never be stored on their side.
• Never store gas bottles indoors.
• This appliance is supplied with a propane regulator which must only be
used for propane gas. NEVER use an adjustable regulator with this appliance.
• Please consult your gas dealer for the most suitable gas bottles for your regulator.
Siting Instructions
• This appliance is for OUTDOOR USE ONLY and should be placed in a well
ventilated area.
• A well ventilated area must have a minimum of 30% of its surface area open.
(Surface area is defined as the total surface of the walls surface.)
• The sides of the appliance should NEVER be closer than
combustible surface.
• Keep this appliance away from any flammable materials!
• Important - Make sure the gas bottle is placed level within the base.
• Should you need to change the gas bottle, confirm the gas supply is turned off at
the regulator or bottle / cylinder valve, and there are no sources of ignition
(cigarettes, open flame, sparks, etc.) near before proceeding.
• For additional safety if required, fix heater securely through the holes in base to a
sound surface (fixings not supplied).
• Inspect the gas hose to ensure it is free from any twisting or tension. The hose
should hang freely with no bends, folds, or kinks that could obstruct free flow of
gas. Always inspect the hose for cuts, cracks, or excessive wear before use. If the
hose is damaged, it must be replaced with hose suitable for use with LPG and
meet the national standards for the country of use.
Connecting to the cylinder
• Confirm all control knobs are in the off position.
• Connect the regulator to the gas bottle according to your regulator and bottle
dealers instructions.
40 inches (1m) from any
Page 14