Mirage HDMIRAGE10 Instruction Manual page 14

For all appliances:
• The heater, when installed, must be electrically grounded in accordance with local codes or, in the absence
of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
• Certain materials or items, when stored under the heater, will be subjected to radiant heat and could be
seriously damaged.
• Inspect the visible portion of the hose before each use of the appliance. When portions of
the hose are located within the confines of the heater post, instructions to inspect the entire hose are
located within the confines of the heater post, instructions shall also include the proper procedure for leak
checking the connections upon re-assembly.
• Children and adults should be alerted to the hazards of high surface temperatures and should stay away to
avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the area of the heater.
• Clothing or other flammable materials should not be hung from the heater, or placed on or near the heater.
• Any guard or other protective device removed for servicing the heater must be replaced prior to operating
the heater.
• Installation and repair should be done by a qualified service person. The heater should be inspected
before use and at least annually by a qualified service person.
More frequent cleaning may be required as necessary. It is imperative that control compartment, burners
and circulating air passageways of the heater be kept clean.
• Keep the appliance area clear and free from combustible materials, gasoline and other flammable
vapors and liquids.
• Do not obstruct the flow of combustion and ventilation air.
• Keeping the ventilation opening(s) of the cylinder enclosure free and clear from debris.
• Clean the appliance, including special surfaces, with recommended cleaning agents, if necessary.
An appliance may be installed with shelter no more inclusive than:
a. With walls on all sides, but with no overhead cover.
b. Within a partial enclosure which includes an overhead cover and no more than two side walls. These side
walls may be parallel, as in a breezeway, or right angles to each other.
c. Within a partial enclosure which includes an overhead cover and three side walls, as long as 30 percent or
more of the horizontal periphery of the enclosure is permanently open.
The LP-gas supply cylinder to be used must be:
a. Constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department
of Transportation (DOT); or the Standard for cylinders, Spheres and Tubes for Transportation of Dangerous
Goods and Commission, CAN/CSA-B339, as applicable;
b. Provided with a listed overfilling prevention device; and
c. Provided with a cylinder connection device compatible with the connection for the appliance.
d. 20LP (9kg) cylinder. LPG capacity 4.7 gallons (17.8 litres) Cylinder Dimensions: Height 17.75 inches
(451mm) and width 12.25 inches (311mm)
e. The LP - gas cylinder used must include a collar to protect the cylinder valve.
A cylinder must be stored outdoors in a well-ventilated area out of reach of children. A disconnected cylinder
must have dust caps tightly installed and must not be stored in a building, garage or any enclosed area.
The pressure regulator and hose must be used and any replacement pressure regulator or hose must be
those as specified by the manufacturer.
Do not store spare LP-gas cylinder under or near this appliance.
Never fill the cylinder beyond 80 percent full; and for appliances designed to use a CGA No. 791 Connection:
'Place the dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only install the type of
dust cap on the cylinder valve that is provided with the cylinder valve.Other types of caps or plugs may result
in leakage of propane.
Page 13