Troubleshooting - Yamaha YSP-1100 Owner's Manual

TROUBLESHOOTING
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit to the standby mode, disconnect the power supply cable and contact
the nearest authorized YAMAHA dealer or service center.
• General
Problem
Cause
Remedy
See
page
This unit fails to turn on when
The power supply cable is not firmly Connect the power supply cable firmly to
23
STANDBY/ON is pressed, or enters
connected to the AC wall outlet or to the the AC wall outlet or to the AC inlet on
the standby mode soon after the
AC inlet on the rear panel of this unit. the rear panel of this unit.
power has been turned on.
This unit has been exposed to a strong Set this unit to the standby mode, -
external electric shock (such as lightning
disconnect the power supply cable, plug
and strong static electricity). it back in after 30 seconds, then use it
normally.
This unit sUddenly enters the
The internal temperature becomes too Wait about I hour for this unit to cool
-
standby mode.
high and the overheat protection circuitry
down and then turn it back on.
has been activated.
The sleep timer has turned the unit off. Turn on the power, and play the source
-
again.
No sound.
Incorrect input or output cable Connect the cables properly. If the
15
connections. problem persists, the cables may be
defective.
No appropriate input source has been Select an appropriate input source with 39
selected.
INPUT or the input selector buttons.
The volume is turned down. Tum up the volume.
41
The sound is muted.
Press MUTE or VOLUME +/- on the
41
remote control to resume audio output
and then adjust the volume level.
Signals this unit cannot reproduce (such
Playa source whose signals can be
-
as PCM signals with more than 96 kHz
reproduced by this unit.
of sampling frequency) are being
Change the system settings of the source
received froma source component.
-
component.
The sound suddenly goes off.
The sleep timer has turned the unit off. Tum on the power, and play the source -
again.
The sound is muted. Press MUTE or VOLUME +/- on the
41
remote control to resume audio output
and then adjust the volume level.
No sound from the effect
You are playing back the source or Press one of the beam mode buttons on
42
channels.
program in the stereo mode or my beam
the remote control to select a multi-
mode. channel playback mode and then try to
play back the source or program once
more.
No sound from the center channel.
The output level of the center channel is Raise the level of the center channel.
72
set to minimum.
No sound from the surround
The output level of the surround Raise the output level of the surround 72
channels.
channels is set to minimum. channels.
No sound from the subwoofer.
BASS OUT in SUB WOOFER SET is set
Select SWFR.
67
to FRONT.
The source does not contain low bass
signals.
r--
86
En