Table of Contents
Advertisement
Chapter 6
Unpacking and Installing the Chassis
Powering Up the Chassis
6 - 12
The right plug, labeled "Primary," connects to the top power supply.
This is called power supply "A" in the CLI's
The left plug, labeled "Redundant," connects to the bottom power
supply. The bottom power supply is power supply "B."
DANGER
A chassis configured with two power supplies has two power cords. In the
event that AC power must be removed from the system, disconnect both
power cords before servicing the unit. Otherwise, there is a risk of electric
shock.
Figure 6.6 Power Switch and Connections
For chassis with a single power supply, use the right power plug
See Power Cord and Cable Requirements, on page 5-5 for power cord and
cable specifications.
Note
The switch requires a dedicated 20A circuit for each AC/DC power supply.
WARNING
Before applying power, ensure that the AC outlet to the switch is properly
grounded.
To power up the chassis, find both ON/OFF toggle switches on the back
panel. Flip both switches to the ON position.
The switch boot wizard runs automatically at switch start-up. See the
sections, Connecting the Console Terminal, on page 7-3 and Booting the
Switch, on page 7-4 for information.
show chassis
command.
Advertisement
Table of Contents
