Rack-Mounting The Chassis; Installing The Front Bezels - F5 ARX 6000 Hardware Installation Manual

Rack-Mounting the Chassis

Installing the Front Bezels

®
ARX 6000 Hardware Installation Guide
An EAI standard rack has holes that you must align with the holes in the
chassis flange. A set of ARX
included in the accessory kit to help with this alignment. These are long,
white stickers with holes in the same pattern as the chassis flange. Line them
up with the holes in the rack to create a visual target for the chassis.
With one person in the front of the chassis and another at the back, carefully
lift the chassis into the rack and align the six holes on each side of the
chassis (flange edges) with the holes in the rack. See Figure 6.4. Use the
alignment templates as a guide.
Figure 6.4 Aligning Chassis Flange with Rack
Align chassis flanges with rack - secure with 6 screws on each side
1. Insert 1-inch (2.5 cm) Phillips-head screws (six on each side)
through the holes and tighten securely.
2. When the chassis is secured in the rack, replace the fan tray and
power supply (or power supplies). Reverse the steps in Removing
the Fan Tray, on page 6-7 and Removing the Power Supplies, on
page 6-7.
After you have reinstalled the fan tray and power supplies in the chassis, you
can install the front bezels over the fan tray and utility bay. The bezels are
shipped in the accessory kit.
Rack-Mounting the Chassis
®
6000 rack-mount-alignment templates are
6 - 9