Table of Contents
Advertisement
PMC Adapter
Problem
Host adapter not
found
SCSI drives not
found
SCSI drive errors
and/or
intermittent
operation
Table 4-3. PMC Adapter Troubleshooting
Possible Solution
The PCI system in your computer is suppose to
automatically configure the bus address
locations. An address conflict is probably not
the problem. If the driver is correctly installed,
a driver message should appear on the screen
during boot-up of your computer.
1. Make sure the adapter is seated properly on the
carrier board.
2. Check for correct configurations of the SCSI bus
cable. A broken wire or inverted wiring can
cause SCSI reset problems.
Verify that the logical volumes and volume
groups are configured, and that the file systems
created with SMIT are mounted
Check that the jumper setting on the
MPMC101/MPMC102 are correct (see
on page
2-3).
Check to see that the last drive on the SCSI bus
is properly terminated (see Connecting to the
SCSI Bus on page 2-6).
PMC Adapter
4
Table 2-1
4-3
Advertisement
Table of Contents
Troubleshooting
