Predator Engines 212cc Owner's Manual page 8
Horizontal engine
Hide thumbs
Also See for 212cc:
- Owner's manual & safety instructions (24 pages) ,
- Owner's manual & safety instructions (24 pages)
Table of Contents
Advertisement
Starting the Engine
Before Starting the Engine
Before starting the engine:
a. Follow the Set Up Instructions in the equipment manual to prepare the equipment.
b. Inspect the equipment and engine.
c. Fill the engine with the proper amount and type of both fuel and oil.
d. Read the Equipment Operation section in the equipment manual.
1. To start a cold engine, move the Choke to the
CHOKE position.
To restart a warm engine, leave the Choke in the
RUN position.
2. Open the Fuel Valve.
3. Slide the Throttle or Speed Control Lever to 1/3
away from the SLOW position (the "turtle").
Note: Some tools have a Speed Control Lever located
elsewhere on the tool which functions the same as the
Throttle. Use the Speed Control Lever in place of the Throttle
when the tool is so equipped.
4. Turn the Engine Switch on.
Page 8
OFF
For technical questions, please call 1-888-866-5797.
1
CHOKE
RUN
2
OFF
ON
3
ON
4
ON
O
I
ITEM 60363
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 212cc and is the answer not in the manual?
Questions and answers
i have a 212cc motor on a mini bike i wrecked the other day an cant get it to turn over now why is that ?
The Predator 212cc engine may not turn over after a mini bike accident due to several possible issues:
1. Compression Problems:
- The cylinder may not be lubricated, especially if the bike was stored or unused after the accident. Add a tablespoon of oil into the spark plug hole and crank the engine a few times.
- The spark plug may be loose or broken, causing a hissing noise. Tighten or replace the spark plug.
- A damaged or loose cylinder head or head gasket can also cause hissing and prevent starting. Tighten the head or replace the gasket if needed.
2. Ignition Issues:
- The spark plug cap may be broken. Replace the spark plug cap.
- There may be incorrect spark timing or a faulty ignition system. A qualified technician should diagnose and repair it.
3. Electrical Problems (Electric Start Models Only):
- The circuit breaker may have tripped. Reset the breaker and check wiring or the starter motor.
Check these areas in order and follow all safety precautions during inspection or repair.
This answer is automatically generated
Where does the wife go from the coil on the212 CC engine.