Returns To The Factory - Peak Beam Systems Maxa Beam Operation Manual

Symptom
The searchlight continuously
strobes and the indicator does not
go out when attempting to turn on
the searchlight
Series 1200 Batteries
Battery hot and will not run
searchlight
Battery runs light for shorter and
shorter duration
MBA-7100 Vehicle Power
Adaptor
Will not run light
All factory returns must have a Return Materials Authorization Number (RMA). We can take no
responsibility for items returned without an authorization number. Please contact us as shown below to
receive a RMA form. Have the following information available when you call.
• Serial numbers of units to be returned
• If known, date of purchase and place where purchased
• Reason for return
• For service returns, a description of the problem
• Method of payment for non-warranty service and freight
Peak Beam Systems, Inc.
3938 Miller Road
Edgemont, PA 19028
(610) 353-8505 (phone)
(610) 353-8411 (fax)
Products returned must be sent freight prepaid along with return shipping instructions and a brief
description of the problem.
Warranty repairs will be returned freight prepaid (domestic returns only) by regular UPS unless requested
otherwise. Any additional freight costs for special handling or export freight charges will be charged to the
customer. All other repairs will be sent freight and repair costs COD unless other arrangements are made.
Troubleshooting
Probable Cause
Defective MBP-5600
Internal Thermal Circuit Breaker
in Battery Tripped
Battery has Developed Memory
No Power
or
Fuse in Adapter Blown

Returns To The Factory

17
(continued)
Call Factory for an RMA; Do
Not Attempt to Use with a
Searchlight until the MBP-5600 is
Disconnect Battery from
Searchlight; Allow to Cool until
Breaker Auto Resets
Discharge Battery until Light
Turns Off and then Recharge;
Repeat Cycle until No
Improvement in Run Time is
Return Battery to Factory for
Computerized Evaluation
Check Power Source
Replace Fuse Located in Plug with
Remedy
Repaired
Observed
or
3AG 15