While Operating Machine - Castex TS-2700 Operator And Parts Manual

3. Turn on main power, vacuum and brush/solution
switches.
NOTE: The brush motors will start when triggers are
activated.
4. Pull triggers to begin scrubbing.
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
5. Turn solution flow control knob to maximum for 30
seconds, then adjust to desired flow (Figure 12).
FIG. 12
6. To operate in reverse, push and hold reverse
switch while pulling triggers (Figure 13).
FIG. 13
7. If additional scrubbing speed is desired, activate
the transport/fast scrub switch.

WHILE OPERATING MACHINE

WARNING: Fire Or Explosion Hazard. Never
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1. Observe amount of solution on floor and adjust
solution flow knob accordingly.
TS- -2700/TS- -3300 (05- -04)
Home Find... Go To..
2. Periodically observe recovery tank for excessive
foam (look through clear lid). If excessive foam
appears, pour a recommended foam control
solution into recovery tank.
ATTENTION: Do not allow foam or water to enter
recovery tank float shut- -off screen, vacuum motor
damage will result. The float shut- -off screen will
not keep foam out. Vacuum damage due to foam
or water is not covered by warranty.
3. Change or turn pads over when worn.
4. If squeegee leaves streaks, raise and wipe blades
with a cloth. Pre-sweep area to prevent streaking.
5. During brief stops, it's not required to turn brush
switch off, the brush will automatically stop when
triggers are released.
6. Observe battery meter needle. When needle
drops into the red zone, recharge batteries.
ATTENTION: Do not continue to run machine
when battery meter needle is in the red zone,
battery damage will result.
7. If additional scrubbing pressure is needed for
small, heavily soiled areas, perform the following:
a. Lower scrub head.
b. Lift pad pressure lever to the locked position
(Figure 14).
NOTE: Scrub head must be lowered to allow pad
pressure lever to be lifted to the locked position. Lower
lever before raising scrub head.
FIG. 14
8. Periodically observe clear tube for remaining
cleaning solution.
9. When solution tank runs dry, transport machine to
draining area (See DRAINING TANKS).
OPERATION
9