Machine Setup; Pre--Operation Checks; Installing Brush Or Pad Drivers - Castex TS-2700 Operator And Parts Manual

3. Carefully install batteries into compartment and
arrange battery posts as shown (Figure 4).
Machine
Front
5
1
4
FIG. 4
ATTENTION: Do not drop batteries into
compartment, battery and machine housing
damage may result. This damage in not covered
by warranty.
4. Connect terminals to battery posts in numerical
order as labeled, RED TO POSITIVE & BLACK
TO NEGATIVE (Figure 4).
5. Double check cable connections before closing up
battery compartment.
6. Turn main power switch on (I) and check battery
meter charge level to ensure batteries are fully
charged. If batteries need charging, see
CHARGING BATTERIES.

MACHINE SETUP

PRE- -OPERATION CHECKS
1. Sweep and dust-mop floor to remove particles and
other debris.
2. Check battery meter charge level to ensure
batteries are fully charged (See CHARGING
BATTERIES).
3. Check that pads or brushes are installed.
4. Check that squeegee is installed.

INSTALLING BRUSH OR PAD DRIVERS

1. Turn main power switch to the off (O) position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
TS- -2700/TS- -3300 (05- -04)
3
2
Home Find... Go To..
2. Raise scrub head. Step down firmly on bottom
brush lift foot pedal to raise (Figure 5).
FIG. 5
3. Unfasten black latch at front of machine and hinge
open skirt housing to access motor hub (Figure 6).
FIG. 6
4. Select recommended pad or brush that best
meets your cleaning needs.
NOTE: Consult your authorized distributor for
pad/brush recommendations.
5. (For Pad Installation) Attach pads to pad drivers
before connecting drivers to motor hub. To attach
pad to driver, remove plastic centerlock ring from
pad driver. Position pad on pad driver and replace
centerlock ring (Figure 7).
FIG. 7
OPERATION
7