Ftg Card Mode Of Operation Overview - LG 32LH240H Owner's Manual

Outlined below is the FTG (Free-To-Guest) setup for individual TV control
1. Set up commercial features of TV/STB. Enter Installer Menu and set all desired items as required. (i.e. Tuning
Band, Start Channel etc.) Refer to the Installation and Setup Guide of the TV/STB.
2. Load the FTG Configuration Application program onto the PC that will be used to configure the FTG card.
3. Install FTG card into TV/STB's MPI card slot and connect PC. (See below)
4. Execute the FTG Configuration Application and create a configuration file.
5. Build a Channel Map and 'Write' it to FTG card. (Converts card from pass-through to FTG mode.)
6. If necessary, make changes to Installer Menu items using FTG Installer Menu Configuration utility and 'Write'
them to FTG card.
7. Save the configuration file (*.rml) for future use.
8. Tune TV/STB to a Logical Channel in the Channel Map.
LMT7Z7 Configured Card in FTG Mode of Operation
FTG CARD
INSTALLER
MENU
CHANNEL
MAP
Different Model TV/STB Function
Card only copies Installer Menu items
and then installs Channel Map.
206-4118
TARGET TV/STB
INSTALLER
MENU
CHANNEL
MAP
RETAINING SCREW
Install after inserting
the LMT7Z7 card.
RETAINING SCREW
Install after inserting
the LMT7Z7 card.

FTG Card Mode of Operation Overview

FTG CARD
INSTALLER
MENU
CHANNEL
MAP
Same Model TV/STB Function
Card installs both Installer Menu items
and Channel Map.
ANTENNA/CABLE INPUT
.
Receives RF signals
M.P.I. INTERFACE
.
Available MPI port
TARGET TV/STB
INSTALLER
MENU
CHANNEL
MAP
P A G E 9