Microcar MC1 Technical Manual page 80

Fit the changer bridge on their support and introduce the 2 fixing
screws.
Tighten the fixing screws of the changer bridge.
(set screws 60N/m)
Grease the 2 axles of the exit transmission and the
entry shaft of the changer bridge.
On the front of the engine cradle, fit a spacer washer
on the 4 fixing inserts of the elastic plots.
Fit the 2 elastic plots and fix them on the cradle with 4 screws
and washers (set screws 12N/m).
80