Specifications - Sony HT-DDW885 Operating Instructions Manual

Specifications

Amplifier section
Models of area code SP, AU, E51
Stereo mode (6 ohms, 1 kHz, THD 1%)
2)
Surround mode (reference) (6 ohms, 1 kHz,
THD 10%)
Models of area code AR
Stereo mode (6 ohms, 1 kHz, THD 1%)
2)
Surround mode (reference) (6 ohms, 1 kHz,
THD 10%)
1)
Measured under the following conditions:
Area code
SP, AR
AU, E51
2)
Reference power output for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no sound output.
3)
Measured under the following conditions:
220 V AC, 50 Hz
72
GB
1)
90 W + 90 W
RMS output
FRONT: 135 W
1)
per channel
1)
CENTER:135 W
SURROUND: 135 W
1)
per channel
SURROUND BACK:
1)
135 W
1)
90 W + 90 W
3)
80 W + 80 W
RMS output
FRONT:
1)
135 W per channel ,
3)
125 W per channel
CENTER:
1) 3)
135 W , 125 W
SURROUND:
1)
135 W per channel ,
3)
125 W per channel
SURROUND BACK:
1) 3)
135 W , 125 W
Power requirements
230 V AC, 50 Hz
240 V AC, 50 Hz
Inputs
Analog
Digital (Coaxial) Impedance: 75 ohms
Outputs (Analog)
AUDIO OUT
SUB WOOFER
Tone
Gain levels
Reproduction frequency range:
FM tuner section
Tuning range
Antenna
Antenna terminals
Intermediate frequency
AM tuner section
Tuning range
Models of area code SP, AU
With 9-kHz tuning scale:
Models of area code E51
With 10-kHz tuning scale:
With 9-kHz tuning scale:
Models of area code AR
With 10-kHz tuning scale:
Antenna
Intermediate frequency
4)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press ?/1. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the
procedure.
Sensitivity: 800 mV/
50 kohms
Voltage: 800 mV/
10 kohms
Voltage: 2 V/1 kohm
±6 dB, 1 dB step
28 – 20,000 Hz
87.5 - 108.0 MHz
FM wire antenna
75 ohms, unbalanced
10.7 MHz
531 – 1,602 kHz
4)
530 – 1,610 kHz
4)
531 – 1,602 kHz
530 – 1,610 kHz
Loop antenna
450 kHz