Advertisement
Quick Links
Advertisement
Related Manuals for James SONIC D
Summary of Contents for James SONIC D
- Page 1 SONIC D USER GUIDE...
-
Page 2: Table Of Contents
INTRODUCTION UNPACKING & IMPORTANT SAFETY INSTRUCTIONS SUGGESTED APPLICATIONS SONIC - D SERIES OPERATION INSTRUCTIONS SONIC - MX SERIES OPERATION INSTRUCTIONS 10-11 DIFFERENT CLEANING METHODS... -
Page 3: Introduction
INTRODUCTION Ultrasonic cleaners function by producing sound waves that are transmitted into the tank and cleaning solution. These waves create millions of microscopic bubbles, which collapse or ‘implode’, releasing large amounts of energy, which scrub the surface clean. This process is called ‘Cavitation’. These tiny bubbles create incredible cleaning results not only to the surface, but by penetrating the finer detail and recesses in small and hard to get areas to restore them to their former glory. -
Page 4: Suggested Applications
SUGGESTED APPLICATIONS TO PREVENT FIRE HAZARDS, PLEASE OBSERVE THE FOLLOWING Never block the vents on the unit. Keep the vents free from lint, hair and other DOMESTIC COMMERCIAL/INDUSTRIAL materials. Jewellery: Necklaces, rings, bracelets, Airbrushes/ Spray-guns Do not place the unit on a soft surface, such as a bed or a sofa, where the vents could etc. -
Page 5: Sonic D Series
SONIC D SERIES OPERATION INSTRUCTIONS Check the specification table for the correct operating requirements (located on the rear of the unit). Before connecting power, put the unit on a stable and flat working surface. Add water to tank, sufficient to completely immerse the items being cleaned. -
Page 6: Sonic Mx Series
SONIC MX SERIES Setting the timer– When power is on, the timing setting figure will flash once option button has been pressed. This indicates that a time setting is required. To set the timer, press the button to set the required cleaning time (Minutes). -
Page 7: Operation Instructions
OPERATION INSTRUCTIONS Use of degassing function: at the normal working state, once the button is Check the specification table for the correct operating requirements pressed, the machine will start the degassing function and the degas button indicator (located on the rear of the unit). lamp will be on. - Page 8 DIFFERENT WAYS OF CLEANING General Cleaning: Only use plain warm water, about 50°C. Enhanced Cleaning: Add a few drops of standard washing up liquid, liquid soap, or detergent into the water, other non-acidic based cleaning agents can be also used. Extensive Cleaning: Removing Tarnish, Carbon and Rust from non-plated metals, it is recommended that you use a specialist cleaning solution such as SeaClean2 that has been developed to work in an ultrasonic cleaner.