Ford 2010 Crown Victoria Owner's Manual page 271

Pin Function
1 Not used
2 Vehicle speed signal
3 Battery saver
4 50A Battery
5 Not used
6 50A Battery
7 20A Run/Acc
8 10A Run/Acc
9 50A Battery
10 Not used
11 50A Battery
12 10A Run/Acc
The mating connector is provided on the end of the power distribution
connector. The vehicle modifier can either purchase pins for the mating
connector and install them on the wires before they are inserted into the
connector, thereby avoiding any splicing, or purchase an optional power
pigtail for the interface. The power pigtail (P/N 14A411) plugs into the
power distribution connector and provides blunt cut wires ready for
splicing by the vehicle modifier.
See the Police Interceptor Modifier Guide for more details.
Rear power point — police
The rear power point is a battery access port for police auxiliary equipment
mounted in the trunk. It is capable of supplying 80 amps of battery power.
The front power distribution box (PDB) contains two 50 amp fuses, which
protects the power point. Battery access is via two studs contained in an
enclosure, mounted in the trunk, on the right side fender support. The
terminal with the red wires is the battery positive, and the terminal with
the black wire is the ground. Remove both fuses in the front PDB before
removing the cover to the rear power point. Ensure load devices can be
turned off, and are switched off when reinserting fuses.
2010 Crown Victoria (cro)
Owners Guide, 1st Printing
USA (fus)
Crown Victoria Severe Duty
Taxi
Gauge
—
20 Gray/Black
18 Light green/Orange
10 Light green
—
10 Tan/Yellow
12 White/Pink
14 Light Blue/White
10
—
10 Red/White
14 Gray/White
Color
—
—
Yellow
—
271